Hi, I have just started using ScreenMonkey and have come up with a few problems which have caused me a lot of grief. I have four short clips that I need to use as a backdrop for a piece of theater. Well when I finally got the show mastered I tried to save it saved as an xml file? I could not then open it as it came up blank! The show mind you is on tomorrow so I am pretty desperate. I tried to begin a new session but when I would bring up the settings it would go behind the screen monkey screen and I could not access it and nor would it allow me to do anything else till I closed it down which I was able to by right clicking. Now when I try to set up the four clips again I cannot get them to work in front as the they will only run behind the screen. Also when I read the instructions on various aspects of screenmonkey like the different controls that exist I can't seem to bring them up. I just can't understand what I am doing wrong? or have I not loaded screenmonkey on properly? And why can't I save my project and access it to use it at the show? I would be grateful if somebody could get back to me asap. The show is on tomorrow.